Antimicrobial Molded Plastic Shower Seat Right Hand; 9561

Description

Product Materials
FRAME: 1" dia. 18 gauge stainless steel tubing. Welded.
WALL BRACKET: 16 gauge stainless steel with stainless steel piano
hinges.
RETAINING BRACKET: 16 gauge stainless steel. Positive bullet-type catch
holds seat securely in up or down position.
SEAT: rotational-molded polyethylene. Provides maximum comfort and flex
without compromising strength. Will not retain heat or cold. Antimicrobial
agent molded into seat to inhibit the growth of bacteria that cause product
degradation.
Operation
Hinged seat folds up and out of the way when not in use. When properly
installed, seat can support up to 250 lbs. – static load.
Installation
Verify all rough-in dimensions prior to installation. Provide concealed
backing or anchors as specified by architect before finished wall is applied.
Secure seat support bracket to wall with mounting screws (not included) at
holes provided. Locate mounting holes 161⁄6" above finished floor. Secure
leg support bracket to wall at locations shown. Mounting kit available from
Bradley. For more information, visit bradleycorp.com.
WARNING: Be sure to use reinforced backing behind wall
where mounting screws or anchoring devices are installed to
ensure adequate support for the shower seat. All anchoring
devices (supplied by installer) must be appropriate for
specific wall construction. Severe personal injury and/or
property damage may result from improper mounting.
Guide Specification
Folding shower seat shall be fabricated of molded polyethylene containing
an antimicrobial agent homogeneously distributed throughout the plastic matrix.
Seat secured to 1" diameter, 18 gauge stainless steel tubing. Support leg
locks into 16 gauge retaining bracket with bullet-type catch. Shower seat shall
meet or exceed ADA guidelines.
Overall dimensions: 34½2"W x 22"D x 3¼" thick